How to improve the production efficiency of hydraulic water well drilling rigs?

How to improve the production efficiency of hydraulic water well drilling rigs? The following editor will tell you about the precautions for using it.

1. After the drill bit of the hydraulic water well drilling rig is drilled into the structure, the center drilling tool needs to be replaced in time. First, the bottom of the hole needs to be cleaned, and then the residue at the bottom of the hole is blown away. After the bit stops rotating, the bit in the hydraulic water well drilling rig is drilled. It is most suitable when the lift force is slowly raised and the lift force is just enough to lift the drill bit.

2. The drilling process summarizes the bit of the hydraulic water well drilling rig. It is also necessary to pay close attention to the subsequent working conditions of the casing, keep abreast of the specific conditions of the borehole, clean the borehole in time, and drill the bit on the water well drilling rig. Strong boosts are prohibited during this process.

3. At the bottom of the hydraulic water well drilling rig, there will be more residue. The eccentric bit will get stuck by the slag and affect its collection production. At this point, compressed air needs to be delivered and the hole re-cleaned. And make the DTH hammer work for a short time, and then re-do the lifting work of the center drill.

The above is the relevant little knowledge about "How to improve the production efficiency of hydraulic water well drilling rigs?", if you have any questions, you can contact our customer service staff of Shandong Yikuang Drilling Technology Co.,Ltd., we will be happy to discuss with you.